Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 73
L2 PROTOCOL (T1[0] - PPP) > CONFIG > PPP > FORCE PEER IP ADDRESS
This option forces the PPP to negotiate the IP address entered instead of allowing the other an address to be
assigned by the remote end. The default is
NO.
L2 PROTOCOL (T1[0] - PPP) > STATUS
View the L2 PROTOCOL status for the T1 interface using the PPP protocol.
L2 PROTOCOL (T1[0] - PPP) > STATUS > LCP
Link Control Protocol. Reflects LCP layer active.
L2 PROTOCOL (T1[0] - PPP) > STATUS > BCP
Shows UP if PPP Bridge Control Protocol has negotiated successfully.
L2 PROTOCOL (T1[0] - PPP) > STATUS > IPCP
Shows UP if PPP IP Control Protocol has negotiated successfully.
L2 PROTOCOL (T1[0] - PPP) > STATUS > UP TIME
Displays how long the PPP session has been connected.
L2 PROTOCOL (T1[0] - PPP) > STATUS > TX PKTS
Number of packets transmitted.
L2 PROTOCOL (T1[0] - PPP) > STATUS > RX PKTS
Number of packets received.
L2 PROTOCOL (T1[0] - PPP) > STATUS > TX BYTES
Number of bytes transmitted.
L2 PROTOCOL (T1[0] - PPP) > STATUS > RX BYTES
Number of bytes received.
L2 PROTOCOL (T1[0] - PPP) > STATUS > CLEAR STATS
Selecting this activator will clear the PPP stats.
To Next Page
Loading...
Need help?
General
