61200600L1-1A © 2002 ADTRAN, Inc. 131
LOGGING IN TO THE SYSTEM
Introduction
Once connected to the unit via either a VT100 terminal or PC configured as a VT100 terminal, it is
necessary to log in to the system to gain access to the management and provisioning functions. This DLP
provides specific steps for logging in to the system and accessing the various management and
provisioning functions.
Prerequisite Procedures
Complete DLP-001, Connecting the Terminal or PC to the CRAFT Port, before logging in to a unit.
Tools and Materials Required
• VT100 compatible terminal or computer with terminal emulation software
• Appropriate cable to connect terminal to the unit (customer-provided)
• DB-9 female to RJ-45 female adapter for connecting to the
CRAFT port on the rear of the unit. This
adapter is ADTRAN-proprietary and is provided with the unit.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
To Next Page
Loading...
