Section 4 User Interface Guide Total Access 600R System Manual
78 © 2002 ADTRAN, Inc. 61200600L1-1A
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > CR COUNT
Number of packets received on this DLCI with the command response (CR) bit set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > BECN COUNT
Number of packets received on this DLCI with the Backward Explicit Congestion Notification (BECN) bit
set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > FECN COUNT
Number of packets received on this DLCI with the Forward Explicit Congestion Notification (FECN) bit
set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > UNKNOWN FRAME RX
Number of frames that have been received that the unit does not know where to route.
L2 PROTOCOL (T1[0] - AUTO)
View the status of the T1 interface with the L2 PROTOCOL set to AUTO (using Auto-config feature).
Reference DLP-014, Unit Installation Using The Auto-Config Feature, for further details.
L2 PROTOCOL (T1[0] - AUTO) > STATUS
View the status of the auto-detect function and traffic flow for the T1 interface with an L2 Protocol set to
auto.
L2 PROTOCOL (T1[0] - AUTO) > STATUS > STATE
This field represents the state of the auto-detect/configuration function. The possible states are:
OFF
The T1 interface is down, so the auto-detect/configuration process is
currently idle.
DETECTING L2
P
ROTOCOL
The T1 interface is up, and waiting for the first control/signaling packet.
CONFIRMING FR
The T1 interface is up, and one FR signaling packet has been received.
CONFIRMED FR
The T1 interface is up, and two FR signaling packets have been received. It
takes two consecutive control/signaling packets of the same type to confirm
the detected protocol.
CONFIRMING PPP
The T1 interface is up, and one PPP control packet has been received.
CONFIRMED PPP
The T1 interface is up, and two PPP control packets have been received. It
takes two consecutive control/signaling packets of the same type to confirm
the detected protocol.
To Next Page
Loading...
Need help?
General
