Name: ADTRAN Total Access 600R
Brand: ADTRAN
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Section 4 User Interface Guide Total Access 600R System Manual

SYSTEM UTILITY > UPGRADE FIRMWARE > TFTP SERVER FILENAME

This is required when the transfer method is TFTP. It is the case-sensitive file name which contains the

upgrade code. The factory default is no entry in the

TFTP SERVER FILENAME field.

SYSTEM UTILITY > UPGRADE FIRMWARE > TRANSFER STATUS

This appears when TFTP is used. It displays the status of the transfer as it happens. Any error or success

message will be displayed here.

SYSTEM UTILITY > UPGRADE FIRMWARE > START TRANSFER

This activator is used when the configurable items in this menu are complete. This will initiate the transfer

for either TFTP or XMODEM upgrades.

SYSTEM UTILITY > UPGRADE FIRMWARE > ABORT TRANSFER

Use this activator to cancel any TFTP transfer in progress.

SYSTEM UTILITY > CONFIG TRANSFER

Select the config transfer method and perform the transfer from this menu.

SYSTEM UTILITY > CONFIG TRANSFER > TRANSFER METHOD

Sends a file containing the unit configuration to a PC connected to the CRAFT port using XMODEM

Protocol or to a file on a TFTP server using the

TFTP protocol.

CONFIG TRANSFER also lets you save the unit configuration as a backup file, so you can use the same

configuration with multiple units. In addition,

CONFIG TRANSFER can retrieve a configuration file from a

TFTP server.

To support these transfers, ADTRAN delivers a TFTP program with the unit called TFTP Server. You can

configure any PC running Microsoft Windows with this software, and store a configuration file.

Only one configuration transfer session (upload or download) can be active at a time.

XMODEM and TFTP

are supported.

Before using START TRANSFER, the unit should have a valid IP address, subnet mask, and

default gateway (if required). See DLP-004, Setting Ethernet IP Parameters for more

information.

Before using START TRANSFER, the unit should have a valid IP address, subnet mask, and

default gateway (if required). See DLP-004, Setting Ethernet IP Parameters, for more

information.

ADTRAN Total Access 600R System Manual

Other manuals for ADTRAN Total Access 600R