ADTRAN Total Access 600R System Manual

140 © 2002 ADTRAN, Inc. 61200600L1-1A
Section 5 DLP-004 Total Access 600R System Manual
DLP-004
1. Connect the unit to your VT100 system (details found in DLP-001, Connecting the Terminal or PC to
the CRAFT Port).
2. Log in to the system with maximum rights (details for logging in are in DLP-002 and
DLP-003).
3. From the R
OUTER/CONFIG/INTERFACES (ETH[1]) menu, select the SETUP option and press <Enter>.
4. Select the P
RIMARY IP option and press <Enter>. Select IP ADDRESS and press <Enter>.
Enter the appropriate IP address.
5. From the ROUTER/CONFIG/INTERFACES (ETH[1])/SETUP/PRIMARY IP menu, select the SUBNET MASK
option and press <Enter>.
Enter the appropriate Subnet Mask.
6. From the ROUTER/CONFIG/ROUTES menu, select the DEFAULT GATEWAY option and press <Enter>.
Enter the appropriate Default Gateway.
7. Escape out to the ROUTER menu and log off by pressing <Ctrl + L>.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Perform Steps Below in the Order Listed

ADTRAN Total Access 600R Specifications

General

Brand	ADTRAN
Model	Total Access 600R
Category	Network Router
Language	English