ADTRAN Total Access 600R - Page 56

Section 4 User Interface Guide Total Access 600R System Manual
56 © 2002 ADTRAN, Inc. 61200600L1-1A
SYSTEM CONFIG > SYSLOG > SELFTEST LEVEL
Minimum required level for sending log messages about selftest.
SYSTEM CONFIG > SYSLOG > VOICE LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > JETSTREAM LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > POTS LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > LESCAS LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > ATM LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > COPPERCOM LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > VOFR LEVEL
(This parameter is not applicable for the Total Access 600R.)
SYSTEM CONFIG > SYSLOG > XMODEM LEVEL
Minimum required level for sending XMODEM log messages for firmware and configuration transfers.
SYSTEM CONFIG > SYSLOG > EMWEB LEVEL
This parameter is for ADTRAN internal use only.
SYSTEM CONFIG > SYSLOG > FRELAY LEVEL
Minimum required level for sending frame relay log messages.
SYSTEM CONFIG > SYSLOG > BRIDGE LEVEL
Minimum required level for sending bridge mode log messages.
SYSTEM CONFIG > SYSLOG > MAINT LEVEL
Minimum required level for sending CRAFT port log messages.