GPIB OPERATION
3-2-31
SWEEP (continued)
:START
Select start value of the parameter to be swept.
:STOP Select stop value of the parameter to be swept.
Data type :
As used for the parameter
Allowed suffices : As used for the parameter
Default suffix : As used for the parameter
:STEP
Select number of steps in the sweep.
Data type :
Decimal Numeric Program Data
Allowed suffices : None
Default suffix : None
:TIME
Select time per sweep step
Data type :
Decimal Numeric Program Data
Allowed suffices : MS
Default suffix : MS
:MKRNUM
Select marker
Data type :
Decimal Numeric Program Data
Allowed suffices : None
Default suffix : None
:MKROFF
Turn Current Marker OFF
:MKRON Turn Current Marker ON
Data type :
None
Allowed suffices : None
Default suffix : None
:VALUE
Set Value of Current Marker
Data type :
Decimal Numeric Program Data
Allowed suffices : As used for the parameter
Default suffix : As used for the parameter
SWEEP?
Prepares message containing information on Sweep Mode,
Type and Marker status in the following format:
:SWEEP:MODE <mode>;TYPE <type>;<status>
where: <mode> is a program mnemonic representing the
sweep mode selected, <type> is a program mnemonic
representing the sweep type selected and <status> is a
program mnemonic indicating whether the Marke
output is ON or OFF.
Sample responses:
:SWEEP:MODE CONT;TYPE CFRQ;MKROFF
:SWEEP:TYPE HOP:MODE SNGL
To Next Page
Loading...
Need help?
General
