96 7713395 R2
Note
When drying in AUTO mode, use small increments of change when making adjustments to either the
burner temperatures or target moisture percentage. For example, to change a burner temperature from
180 to 220, adjust to 200 for five to ten minutes, then increase to 220. Use a similar approach to making
moisture percentage changes.
Metering Roll Pause/Resume
• Pause the metering rolls to temporarily stop the discharge of grain from the dryer. This is typically used
when switching between drying bins. When paused, the grain stops discharging from the dryer. The unload
and dry transports keep running and empty out. Once empty, the grain is re-directed to a new dry bin
location. If the Resume button is not pushed before the timer reaches zero, the dryer will shut down.
Note
As the various operation stages occur, the display screen center panel area provides the operator with
important status information. See the following example:
4. OPERATION CONTINUOUS MIXED-FLOW GRAIN DRYER WITH COMMANDER CONTROL SYSTEM
To Next Page
Loading...