EasyManua.ls Logo

Agilent Technologies 83620B

Agilent Technologies 83620B
496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents
1. Getting Started
What Is In This Chapter . . . . . . . . . . . . 1-1
HowTo Use This Chapter . . . . . . . . . . . . 1-2
Equipment Used In Examples . . . . . . . . . 1-2
Intro ducing the Agilent 8360 B-Series Swept Signal
Generators . . . . . . . . . . . . . . . . . 1-3
Display Area . . . . . . . . . . . . . . . . . . 1-4
Entry Area . . . . . . . . . . . . . . . . . . 1-5
CW Op eration and Start/Stop Frequency Sweep . . 1-6
CW Op eration . . . . . . . . . . . . . . . . 1-6
Start/Stop Frequency Sweep . . . . . . . . . . 1-6
Center Frequency/Span Op eration . . . . . . . . 1-8
Power Level and Sweep Time Operation . . . . . . 1-10
Power Level Operation . . . . . . . . . . . . 1-10
Sweep Time Operation . . . . . . . . . . . . 1-10
Continuous, Single, and Manual Sweep Operation . 1-12
Marker Op eration . . . . . . . . . . . . . . . 1-14
Saving and Recalling an Instrument State . . . . . 1-16
Power Sweep and Power Slop e Op eration . . . . . 1-18
Power Sweep Operation . . . . . . . . . . . . 1-18
Power Slop e Operation . . . . . . . . . . . . 1-19
Getting Started Advanced . . . . . . . . . . . . 1-21
Externally Leveling the Swept Signal Generator . . 1-23
Leveling with Detectors/Couplers /Splitters . . . 1-23
External Leveling Used With the Optional Step
Attenuator . . . . . . . . . . . . . . . 1-26
Leveling with Power Meters . . . . . . . . . . 1-27
Leveling with MM-wave Source Mo dules . . . . . 1-28
Working with Mixers/Reverse Power Eects . . . . 1-30
Working with Spectrum Analyzers/Reverse Power
Eects . . . . . . . . . . . . . . . . . . . 1-32
Optimizing Swept Signal Generator Performance . . 1-33
Creating and Applying the User Flatness Correction
Array . . . . . . . . . . . . . . . . . . 1-33
Creating a User Flatness Array Automatically,
Example 1 . . . . . . . . . . . . . . . 1-34
Creating a User Flatness Array, Example 2 . . 1-36
Swept mm-wave Measurement with Arbitrary
Correction Frequencies, Example 3 . . . . 1-39
Scalar Analysis Measurement with User Flatness
Corrections, Example 4 . . . . . . . . . 1-43
Using Detector Calibration . . . . . . . . . . 1-47
Contents-1

Table of Contents

Related product manuals