Agilent Technologies 83620B User Manual

4
START
5
4
SPAN
5
Function Group
FREQUENCY
Menu Map
2
Description
This hardkey lets you set a value for the frequency span in the center
frequency/frequency span mo de of swept frequency op eration. Press
4
SPAN
5 , and use the entry area to enter the desired value. The swept
signal generator sweeps from one half the span b elow to one half
above the center frequency.
Certain center frequency and frequency span combinations cause the
swept signal generator to limit the value entered. In general, any
combination that causes the swept signal generator to exceed its
minimum or maximum sp ecied frequency is limited.
Programming Codes
SCPI:
FREQuency:SPAN < num > [freq sux] or
MAXimum j MINimum j UP j DOWN
FREQuency:MODE SWEep
Analyzer: DF < num > [Hz j Kz j Mz j Gz]
See Also
4
CENTER
5 , 4
START
5 , 4
STOP
5
\Center Frequency/Span Operation" in Chapter 1
4
START
5
Function Group
FREQUENCY
Menu Map
2
Description
This hardkey activates swept frequency mo de and makes the start
frequency parameter the active function. Press 4
START
5 and use the
entry area to enter the desired value. The start/stop frequency must
be separated by at least 2 Hz in order to remain in the frequency
sweep mo de. If start=stop frequency then the zero span mo de is
entered.
Operating and Programming Reference S-61

Agilent Technologies 83620B Specifications

General

Brand	Agilent Technologies
Model	83620B
Category	Inverter
Language	English