NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Auto Fill Stop
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Auto Fill Stop
Function Group
FREQUENCY, POWER
Menu Map
2, 5
Description
This softkey is used in two lo cations:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
and
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
. The op eration is the same in b oth applications.
This softkey enables the entry of a stop frequency used to determine
the ending frequency of the automatic lling array. The array is not
created until either the incrementvalue or the number of p oints is
assigned. The auto ll stop frequency does not aect the swept signal
generator stop frequency. When
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Auto Fill Stop
is selected, the
active entry area indicates:
--> Fill Stop: XXXXXXXXX MHz
where X represents a numeric value. Unless a previous entry was
made, the display indicates the swept signal generator maximum
frequency.
Programming Codes
SCPI:
NONE, see
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
or
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
Analyzer:
NONE
See Also
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Fltness Menu
,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
List Menu
\Optimizing Swept Signal Generator Performance" in Chapter 1
Operating and Programming Reference A-27
To Next Page
Loading...
