Agilent Technologies 83620B

E
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
8360 Adrs
Function Group
SYSTEM
Menu Map
8
Description
This softkey lets you change the GPIB address of the swept signal
generator. Enter the address desired using the numeric entry keys
or the up/down arrowkeys. The address value may b e set b etween
0 and 30. The swept signal generator stores the address value
in non-volatile memory. The default address of the swept signal
generator is 19.
Programming Codes
SCPI: SYSTem:COMMunicate:GPIB:ADDRess
Analyzer: NONE
See Also
Connectors,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
GPIB Menu
\Instrument Addresses" in Chapter 1
\Programming Typical Measurements" in Chapter 1
Operating and Programming Reference E-1