Agilent Technologies 83620B

2c
Specifications
This section lists the sp ecications for the Agilent 8360 B-Series
swept signal generator. In a eort to improve these swept signal
generators, AgilentTechnologies has made changes to this pro duct
which are identied with changes in the serial number prex.
Tocheckifyour swept signal generator sp ecications are the same as
those listed in this section:
1. Lo cate your instrument mo del number and serial prex number in
the \Instrument History Changes" table in Chapter 5.
2. Check the right column of this table to determine whether any
changes apply to your instrument's mo del number/serial prex
number combination.
3. If a change is listed, check this change to determine if
specications other than those listed in this section apply
. The
changes are included in Chapter 5.
Sp ecications describ e warranted instrument p erformance over the 0 to +55

C
temp erature range except as noted otherwise. Sp ecications apply after full user
calibration and in coupled attenuator mo de of op eration (ALC level greater than
0 10 dBm). Supplemen tal characteristics, denoted typical or nominal, are intended to
provide information useful in applying the instrument, but are non-warran
ted
parameters.
Specifications 2c-1