1
Getting Started
What Is In This
Chapter
This chapter contains information on how to use the Agilent
8360 B-Series swept signal generator. The information is separated
into three sections.
Basic
For the novice user unfamiliar with the 8360 B-Series
swept signal generator. This section describes the
basic features of the swept signal generator.
Advanced
For the user familiar with swept signal generators,
but not necessarily familiar with ho
w to use the
special features of the 8360 B-Series swept signal
generator.
Programming
For the user wishing to program an 8360 B-Series
swept signal generator. This section contains
an introduction to Standard Commands for
Programmable Instruments language (SCPI), Agilent
Technologies' implementation of IEEE-488.2-1987,
and an intro duction to the Analyzer programming
language.
Note
If you are unpacking a new swept signal generator, refer to the
installation suggestions provided in Chapter 3, \Installation".
Getting Started Introduction 1-1
To Next Page
Loading...
