Agilent Technologies 83620B

SCPI COMMAND SUMMARY
measured and the absolute value of the peak percent deviation to be
returned.
 MEASure:FM
A query-only command that causes the mo dulating FM signal level
to be measured and the corresp onding p eak frequency deviation
returned.
 MODulation:OUTPut:SOURce AM|FM
 MODulation:OUTPut:SOURce?
Sets and queries the source of the rear panel output mo dulation
BNC.
 MODulation:OUTPut:STATe ON|OFF|1|0
 MODulation:OUTPut:STATe?
Sets and queries the state of the rear panel output mo dulation BNC.
 MODulation:STATe?
Queries the status of any mo dulation. If any of the mo dulation states
are on, then it returns a 1, otherwise it returns a 0.
Power Subsystem
Any place where dBm is accepted as a sux, an
y level sux is
accepted also. In the absence of a sux, the units are assumed to b e
as set by the UNIT:POW command.
 POWer:ALC:BANDwidth|:BWIDth <num>[freq
suffix]|MAXimum|MINimum
 POWer:ALC:BANDwidth?|:BWIDth? [MAXimum|MINimum]
Sets and queries the ALC bandwidth. This is actually not
continuously variable, so the input is rounded to the nearest p ossible
switch position. *RST setting is automatically determined since AUTO
is ON .
 POWer:ALC:BANDwidth|:BWIDth:AUTO ON|OFF|1|0
 POWer:ALC:BANDwidth|:BWIDth:AUTO?
Sets and queries the automatic ALC bandwidth selection switc
h. The
*RST value is ON .
 POWer:ALC:CFACtor <num>[DB]|MAXimum|MINimum|UP|DOWN
 POWer:ALC:CFACtor? [MINimum|MAXimum]
Sets and queries the coupling factor used when the command
POWer:ALC[:SOURce] is set to DIODe or PMETer .
 POWer:ALC:SOURce INTernal|DIODe|PMETer|MMHead
 POWer:ALC:SOURce?
Operating and Programming Reference S-41