Agilent Technologies 83620B

SCPI COMMAND SUMMARY
Table S-1. 8360 SCPI COMMAND SUMMARY (continued)
Command Parameters Parameter Type
1
Allowed Values
:STATus
:QUEStionable
:CONDition?
:ENABle SRQ enable register numeric 0 to 2047
[:EVENt]?
:NTRansition neg transition lter numeric 0 to 2047
:PTRansition pos transition lter numeric 0 to 2047
:SWEep
:CONTrol
:STATe dual source mo de Bo olean ON j OFF j 1 j 0
:TYPE typ e of
sweep control
discrete MASTer j SLAVe
:DWELl settling time
plus dwell time
extended numeric 0.1 to 3200 ms
or MAXimum j MINimum
:AUTO dwell calculation
state
Bo olean ON j OFF j 1 j 0
:GENeration typ e of sweep discrete STEPp ed j ANALog
:MANual
:POINt step p oint number numeric 1 to the number of step p oints
[:RELative] p ercentofsweep extended numeric 0 to 100%
:MARKer
:STATe state Bo olean ON j OFF j 1 j 0
:XFER M1=start,
M2=stop
:MODE manual sweep
mode switch
discrete AUTO j MANual
:POINts p oints in step sweep numeric < num > j MAXimum j MINimum
:STEP step size extended numeric function of current span
MAXimum j MINimum
:TIME sweep time extended numeric 200s to 133 ms or
MAXimum j MINimum
:AUTO auto sweep
time switch
Bo olean ON j OFF j 1 j 0
:LLIMit fastest sweep
time
extended numeric < num > [time sux]
or MAXimum j MINimum
:TRIGger
:SOURce stepp ed trig source discrete IMMediate j BUS j EXTernal
Operating and Programming Reference S-25