Agilent Technologies 83620B

example program
atness correction, 1-103
GPIB check, 1-90
lo cal lo ckout, 1-91
lo oping and synchronization, 1-99
setting up a sweep, 1-93
synchronous sweep, 1-101
use of queries, 1-95
use of save/recall, 1-97
example programs, 1-87{105
examples, equipment used, 1-2
examples, simple program messages, 1-72
example, stimulus response program, 1-77
extended numeric parameters
discussed in detail, 1-84
explained briey, 1-74
extenders
GPIB, C-9
EXTernal
trigger source dened, 1-119
external ALC BNC, L-3, L-4
external ALC connector, C-5
external AM, A-16
external detector calibration, E-6
external detector leveling, L-3
external frequency standard, T-1
external leveling, 1-23{29
coupling factor, C-12
detector calibration, E-6
low output, 1-26
theory of, A-7
with detectors, couplers, or splitters, 1-23{26
with p ower meters, 1-27
with source mo dules, 1-28
external power meter range, P-23
external pulse mo dulation, P-18
external trigger
frequency list, L-9
external trigger, stepp ed sweep, S-70
external trigger, sweep mo de, S-63
F
factor, coupling, C-12
factory preset, P-10
factory-set interface addresses, 3-7
fan lter, clean, 4-5
fastest sweep-retrace cycle, S-62
fault information, F-1
fault information 1, F-2
fault information 2, F-3
fault menu, F-1
fault status
clear, C-2
feature status, D-6
lter
Index-8