Agilent Technologies 83620B - Page 494

swept signal generator, no front-panel change address, 3-8
swept signal generator remote address, A-1, E-1
swept signal generator reset command, S-15
swept signal generator status, D-6
switch, line, L-5
synchronization command, S-14
synchronization, example program, 1-99
synchronous sweep, example program, 1-101
synchronous sweep op eration, interface bus, S-17
syntax diagrams
commands, 1-81
message terminators, 1-80
program message, 1-80
response message, 1-82
syntax drawings, 1-57
system controller on bus message, 2a-4
system interface connector, C-7
system language (SCPI), P-14
system menukeys, S-77
T
tab
proper use of, 1-69
talker, denition of, 1-56
temperature, op erating, 3-9
terminators
program message, 1-64, 1-81
program message:use in examples, 1-64
response message, 1-65
time, sweep set automatically, S-76
tmr conct fail, F-4
track fail, F-2
tracking, 1-49
tracking functions, T-3
transition lter, 1-107
in general status register mo del, 1-106
*TRG, S-17
*TRG[trg], 1-119
triangle
AM waveform, I-4
FM waveform, I-7
trigger
automatic, frequency list, L-8
stepped sweep automatic, S-69
stepped sweep external, S-70
sweep mo de external, S-63
trigger commands
dened, 1-118
trigger functions
list mo de, P-14
trigger, group execute command, S-17
TRIGGER (HP BASIC), 1-119
trigger input BNC, S-71
trigger input connector, C-6
trigger, interface bus
Index-25