Agilent Technologies InfiniiVision 2000 X-Series - Page 116

116 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
9 Triggers
• Digital channel (on mixed- signal oscilloscopes), D0 to the number of
digital channels minus one.
• External — triggers on the rear panel EXT TRIG IN signal.
• Line — triggers at the 50% level of the rising or falling edge of the AC
power source signal.
• WaveGen — triggers at the 50% level of the rising edge of the
waveform generator output signal. (Not available when the DC or
Noise waveforms are selected.)
You can choose a channel that is turned off (not displayed) as the
source for the edge trigger.
The selected trigger source is indicated in the upper- right corner of the
display next to the slope symbol:
• 1 through 4 = analog channels.
• D0 through Dn = digital channels.
• E = External trigger input.
• L = Line trigger.
• W = Waveform generator.
4 Press the Slope softkey and select rising edge, falling edge, alternating
edges, or either edge (depending on the selected source). The selected
slope is displayed in the upper- right corner of the display.