Agilent Technologies InfiniiVision 2000 X-Series - Install the Optional LAN;VGA or GPIB Module; Tilt the Oscilloscope for Easy Viewing

22 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
1 Getting Started
Install the Optional LAN/VGA or GPIB Module
If you need to install a DSOXLAN LAN/VGA module or a DSOXGPIB GPIB
module, perform this installation before you power on the oscilloscope.
1 If you need to remove a module before installing a different module,
pinch the module's spring tabs, and gently remove the module from the
slot.
2 To install a module, slide the module into the slot on the back until it
is fully seated.
The module's spring tabs will latch into the slot, keeping the module in
place.
Tilt the Oscilloscope for Easy Viewing
There are tabs under the oscilloscope's front feet that can be flipped out
to tilt the oscilloscope.
a
a
 :DWWV0$;
9+]
9+]
:$51,1*0$,17$,1
*5281'72 $92,'
(/(&75,&6+2&.
LAN/VGA Module
GPIB Module
Module Slot
NOTE
The LAN/VGA or GPIB module must be installed before powering on the oscilloscope.