Utility Settings 19
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 253
Configuring the [Quick Action] Key
The [Quick Action] key lets you perform common, repetitive actions by
pressing a single key.
To configure the [Quick Action] key:
1 Press [Utility] > Quick Action > Action; then, select the action that should be
performed:
• Off — disables the [Quick Action] key.
• Quick Measure All — displays a popup containing a snapshot of all the
single waveform measurements. The Source softkey lets you select the
waveform source (which also becomes the source selection in the
Measurement Menu). See Chapter 13, “Measurements,” starting on
page 169.
• Quick Print — prints the current screen image. Press Settings to set up
the printing options. See Chapter 18, “Print (Screens),” starting on
page 231.
• Quick Save — saves the current image, waveform data, or setup. Press
Settings to set up the save options. See Chapter 17, “Save/Recall
(Setups, Screens, Data),” starting on page 217.
• Quick Recall — recalls a setup, mask, or reference waveform. Press
Settings to set up the recall options. See Chapter 17, “Save/Recall
(Setups, Screens, Data),” starting on page 217.
• Quick Freeze Display — freezes the display without stopping running
acquisitions or un- freezes the display if currently frozen. For more
information, see "To freeze the display" on page 105.
• Quick Trigger Mode — toggles the trigger mode between Auto and
Normal, see "To select the Auto or Normal trigger mode" on
page 136.
• Quick Clear Display — clears the display, see "To clear the display" on
page 104.
Once the [Quick Action] key is configured, you simply press it to perform
the selected action.
To Next Page
Loading...
