Agilent Technologies InfiniiVision 2000 X-Series User Manual

276 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
21 Reference
Probes and Accessories
This setion lists the probes and accessories that are compatible with the
2000 X-Series oscilloscopes.
• "Passive Probes" on page 276
• "Differential Probes" on page 277
• "Current Probes" on page 277
• "Accessories Available" on page 278
Because the 2000 X-Series oscilloscopes do not have a ring around the
BNC connector for identifying probes, you must set the probe attenuation
factor manually. See "To specify the probe attenuation" on page 60.
See Also For more information on probes and accessories, see "www.agilent.com"
for:
• "Probes and Accessories Selection Guide (5989- 6162EN)"
• "5000, 6000, and 7000 Series InfiniiVision Oscilloscope Probes and
Accessories Data Sheet (5968- 8153EN)"
Passive Probes
Passive probes are included with the 2000 X- Series oscilloscopes for each
analog channel.
The following passive probes can be used with the InfiniiVision
2000 X-Series oscilloscopes. Any combination of passive probes can be
used.
Table 6 Passive Probes
Model Description
1165A Passive probe, 10:1, 600 MHz, 1.5 m
10070C/D Passive probe, 1:1 20 MHz, 1.5 m
10073C Passive probe, 10:1, 500 MHz, 1.5 m
10074C Passive probe, 10:1, 150 MHz, 1.5 m
10076A/B Passive probe, 100:1, 4 kV, 250 MHz

Agilent Technologies InfiniiVision 2000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 2000 X-Series
Category	Test Equipment
Language	English