Agilent Technologies InfiniiVision 2000 X-Series - To Select Generated Waveform Types and Settings; 17, Save;Recall (Setups, Screens, Data

205
Agilent InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
s1
16
Waveform Generator
To select generated waveform types and settings 205
To output the waveform generator sync pulse 208
To specify the expected output load 209
To use waveform generator logic presets 209
To add noise to the waveform generator output 210
To add modulation to the waveform generator output 210
To restore waveform generator defaults 215
A waveform generator is built into the oscilloscope. It is enabled by
Option WGN or the DSOX2WAVEGEN upgrade. The waveform generator
gives you an easy way to provide input signals when testing circuitry with
the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope
setups. See Chapter 17, “Save/Recall (Setups, Screens, Data),” starting on
page 217.
To select generated waveform types and settings
1 To access the Waveform Generator Menu and enable or disable the
waveform generator output on the front panel Gen Out BNC, press the
[Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is
illuminated. When waveform generator output is disabled, the [Wave
Gen] key is off.
The waveform generator output is always disabled when the instrument
is first turned on.