Agilent Technologies InfiniiVision 2000 X-Series User Manual

Measurements 13
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 175
Top
The Top of a waveform is the mode (most common value) of the upper
part of the waveform, or if the mode is not well defined, the top is the
same as Maximum. The Y cursor shows the value being measured.
See Also • "To isolate a pulse for Top measurement" on page 175
To isolate a pulse for Top measurement
The following figure shows how to use Zoom mode to isolate a pulse for a
Top measurement.
You may need to change the measurement window setting so that the
measurement is made in the lower, Zoom window. See "Measurement
Window with Zoom Display" on page 188.
Figure 33 Isolating area for Top measurement

Agilent Technologies InfiniiVision 2000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 2000 X-Series
Category	Test Equipment
Language	English