Save/Recall (Setups, Screens, Data) 17
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 229
7 If you would like to clear the display of everything except the reference
waveform, press Clear Display.
Recalling Default Setups
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default Menu, press one of these softkeys:
• Default Setup— recalls the oscilloscope's default setup. This is the same
as pressing the front panel [Default Setup] key. See "Recall the Default
Oscilloscope Setup" on page 25.
Some user settings are not changed when recalling the default setup.
• Factory Default— recalls the oscilloscope's factory default settings.
You must confirm the recall because there are no user settings that
are left unchanged.
Performing a Secure Erase
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press Default/Erase.
3 In the Default menu, press Secure Erase.
This performs a secure erase of all non- volatile memory in compliance
with National Industrial Security Program Operation Manual (NISPOM)
Chapter 8 requirements.
You must confirm the secure erase, and the oscilloscope will reboot
when finished.
To Next Page
Loading...
