28 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
1 Getting Started
If necessary, use a nonmetallic tool (supplied with the probe) to adjust
the trimmer capacitor on the probe for the flattest pulse possible.
On the N2862/63/90 probes, the trimmer capacitor is the yellow
adjustment on the probe tip. On other probes, the trimmer capacitor is
located on the probe BNC connector.
7 Connect probes to all other oscilloscope channels (channel 2 of a
2- channel oscilloscope, or channels 2, 3, and 4 of a 4- channel
oscilloscope).
8 Repeat the procedure for each channel.
Learn the Front Panel Controls and Connectors
On the front panel, key refers to any key (button) you can press.
Softkey specifically refers to the six keys that are directly below the
display. The legend for these keys is directly above them, on the display.
Their functions change as you navigate through the oscilloscope's menus.
For the following figure, refer to the numbered descriptions in the table
that follows.
Perfectly compensated
Over compensated
Under compensated
To Next Page
Loading...
