101
Agilent InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
s1
7
Display Settings
To adjust waveform intensity 101
To set or clear persistence 103
To clear the display 104
To select the grid type 104
To adjust the grid intensity 105
To freeze the display 105
To adjust waveform intensity
You can adjust the intensity of displayed waveforms to account for various
signal characteristics, such as fast time/div settings and low trigger rates.
Increasing the intensity lets you see the maximum amount of noise and
infrequently occurring events.
Reducing the intensity can expose more detail in complex signals as
shown in the following figures.
1 Press the [Intensity] key to illuminate it.
This key is located just below the Entry knob.
2 Turn the Entry knob to adjust the waveform instensity.
Waveform intensity adjustment affects analog channel waveforms only (not
math waveforms, referencewaveforms, digital waveforms, etc.).
To Next Page
Loading...
Need help?
General
