Agilent Technologies InfiniiVision 2000 X-Series - To Perform Front Panel Self Test; To Display Oscilloscope Information; To Display the User Calibration Status; To Clean the Oscilloscope

Utility Settings 19
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 251
To perform front panel self test
Pressing [Utility] > Service > Front Panel Self Test lets you test the front panel
keys and knobs as well as the oscilloscope display.
Follow the on- screen instructions.
To display oscilloscope information
Press [Help] > About Oscilloscope to display information about your
oscilloscope:
• Model number.
• Serial number.
• Bandwidth.
• Module installed.
• Software version.
• Installed licenses. See also "Loading Licenses and Displaying License
Information" on page 279.
To display the user calibration status
Pressing [Utility] > Service > User Cal Status displays the summary results of
the previous User Cal, and the status of probe calibrations for probes that
can be calibrated. Note that passive probes do not need to be calibrated.
Results:
User Cal date:
Change in temperature since last User Cal:
Failure:
Comments:
Probe Cal Status:
To clean the oscilloscope
1 Remove power from the instrument.
2 Clean the external surfaces of the oscilloscope with a soft cloth
dampened with a mixture of mild detergent and water.
3 Make sure that the instrument is completely dry before reconnecting it
to a power source.