Agilent Technologies InfiniiVision 2000 X-Series User Manual

174 Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
13 Measurements
The units of math waveforms are described in "Units for Math
Waveforms" on page 65.
• "Peak-Peak" on page 174
• "Maximum" on page 174
• "Minimum" on page 174
• "Amplitude" on page 174
• "Top" on page 175
• "Base" on page 176
• "Overshoot" on page 176
• "Preshoot" on page 177
• "Average" on page 178
• "DC RMS" on page 178
• "AC RMS" on page 179
Peak-Peak
The peak- to- peak value is the difference between Maximum and Minimum
values. The Y cursors show the values being measured.
Maximum
Maximum is the highest value in the waveform display. The Y cursor
shows the value being measured.
Minimum
Minimum is the lowest value in the waveform display. The Y cursor shows
the value being measured.
Amplitude
The Amplitude of a waveform is the difference between its Top and Base
values. The Y cursors show the values being measured.

Agilent Technologies InfiniiVision 2000 X-Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 2000 X-Series
Category	Test Equipment
Language	English