Agilent Technologies InfiniiVision 2000 X-Series - To Connect the Digital Probes to the Device under Test

81
Agilent InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
s1
6
Digital Channels
To connect the digital probes to the device under test 81
Acquiring waveforms using the digital channels 85
To display digital channels using AutoScale 85
Interpreting the digital waveform display 86
To switch all digital channels on or off 88
To switch groups of channels on or off 88
To switch a single channel on or off 88
To change the displayed size of the digital channels 87
To reposition a digital channel 89
To change the logic threshold for digital channels 88
To display digital channels as a bus 90
Digital channel signal fidelity: Probe impedance and grounding 93
To replace digital probe leads 98
This chapter describes how to use the digital channels of a Mixed- Signal
Oscilloscope (MSO).
The digital channels are enabled on MSOX2000 X- Series models and
DSOX2000 X- Series models that have the DSOX2MSO upgrade license
installed.
To connect the digital probes to the device under test
1 If necessary, turn off the power supply to the device under test.