Subsystem Command Reference 6
N9310A User’s Guide 119
Sweep Repeat
:SWEep:REPeat SINGle|CONTinuous
:SWEep:REPeat?
This command toggles the sweep repeat between single and
continuous.
The query returns the current sweep repeat state.
Sweep Trigger
:SWEep:STRG IMMediate|KEY|EXT
:SWEep:STRG?
This command sets the sweep trigger mode to one of the
following choices:
• IMMediate
- Selecting this mode immediately triggers
signal generator
to sweep from the first point to the final
point in a sweep sequence automatically.
• KEY - Selecting this mode arms a sweep. The armed
sweep will be initiated by sending the
“TRIGger:IMMediate” command.
• EXT - Selecting this mode enables an external trigger
source to initiate an armed sweep.
The query returns the current sweep trigger mode.
Range SINGle/CONTinuous
*RST value CONTinuous
Returned data SING, CONT
Front panel access Sweep > Sweep Repeat
Range IMMediate, KEY, EXT
*RST value IMMediate
Returned data IMM, KEY, EXT
Front panel access Sweep > Sweep Trigger
To Next Page
Loading...
Need help?
General
