88
Chapter 9: Control Panel
TIME DISPLAY (Setting the time counter display)
This function has the following parameters related to the time counter display.
A
B
C
In this screen, you can select a format for the time counter, select absolute time or relative time, and set a frame
rate. The parameters have the following functions.
1
Style
(display format)
This select field enables you to set a format for the time displayed on the time counter and in various time
fields. Use the [CURSOR] key to move the cursor to this field, and turn the [JOG] dial to select the setting.
There are two options.
•
TIME
(time display) ............................................. time/minute/second/frame/sub-frame
•
BAR.BEAT.CLOCK
(measure display)................ measure/beat/clock
When
TIME
is selected
When
BAR.BEAT.CLOCK
is selected
➸
NOTE :
Changes in this parameter value will be reflected on all time indications on the DPS12.
✐
TIP :
While you are synchronizing a MIDI sequencer to the MIDI clock transmitted from the DPS12,
selecting
BAR.BEAT.CLOCK
will allow you to specify the locate points and/or edit points in steps of
measures and beats.
2
Type
(switching between absolute time and relative time)
This parameter enables you to select absolute time or relative time as the time counter value. Use the [CUR-
SOR]
key to move the cursor to this field, then use the [JOG] dial to set the parameter. There are two options.
•
ABSOLUTE
.............Absolute time referenced to the DPS12’s internal zero point (00:00:00:00.0).
•
RELATIVE
..............Relative time referenced to any zero point you set (00:00:00:00.0).
✐
TIP :
Use the TIME OFFSET Control Panel to specify a zero point for relative time. (See page 89.)
To Next Page
Loading...
Need help?
General
