Akai DPS12 - Type and function of edit commands

70
Chapter 6: Mixer Function
2. Press the RECALL [F4] key.
The scene is recalled, and the DPS12 returns to the last Mixer mode that was obtained before you recalled the
scene memory.
➸ NOTES :
• When you recall a scene, the current Mixer parameter settings are replaced with those in the recalled
scene. If necessary, store the current Mixer parameter settings before you recall a scene.
• The LEVEL parameter and PAN parameter settings for the TRACK MIX channels that are recalled may
sometimes not match the actual position of the controllers on the top panel (faders and [PAN] controls).
If a parameter setting does not match the position of the actual control, a dot (•) appears in the graphi-
cal field.
• This screen example shows that the level value for TRACK MIX channels 3 and 4 do not match the
actual position of the channel faders. In this case, move the corresponding channel faders past the
current setting values, and the dot will disappear and the bar graph will indicate a new level to match
the current fader position. Note that you cannot change the value by moving the fader until a dot
indicator disappears.
Erasing a scene
Follow the procedure below to erase a stored scene.
1. In the SCENE MEMORY window, move the cursor to select the scene you wish to erase.
2. Press the ERASE [F4] key.
The selected scene will be erased.