101
Chapter 10: Project management
3. Move the cursor to the select field 1 and select
DAT
.
4. Move the cursor to the select field 2 and select a Project for backup.
5. Move the cursor to the select field 3 and select a sampling rate for recording on the DAT recorder
(
32kHz
,
44.1kHz
,
48kHz
).
If you select
DAT
in field 1, select field 3 becomes the
Sampling freq
field, where you can select a
sampling rate for the backup operation.
6. Press the
DO IT
[F6] key.
The following window appears.
7. Start recording on the DAT recorder and press the
START
[F5] key.
Start the backup operation. When the operation is complete, the display returns to the PROJECT screen.
➸
NOTE :
• The time required for the backup operation depends on the sampling rate.
• The backup data does not contain the UNDO data.
CAUTION :
Do not monitor the audio via the DAT during the backup operation. Since audio and other
data is transmitted as a digital signal, an attempt to monitor it may damage the speakers.
✐
TIP :
Press the
CANCEL
[F2]
key to cancel the backup operation.
Reloading the backup Project
Follow the steps below to reload the backup Project from an external DAT or SCSI device.
■ Loading from a SCSI device
1. Press the
RELOAD
[F3] key in Project mode.
The DATA RELOAD window appears.
2. Select
SCSI
in the
Device
field.
3. Select the
SCSI ID
in the SCSI ID field for the disk from which you wish to reload the backup data.
4. Press the
DO IT
[F5] key.
➸
NOTE :
If you are reloading data stored on multiple disks, the following window appears. Insert the
next disk.
✐
TIP :
Press the
CANCEL
[F2]
key to cancel the reload operation.
To Next Page
Loading...
Need help?
General
