receive the the device log.
Note:
The remote system server is provided by Akuvox.
5.11.2. PCAP for Debugging
PCAP in door phone is used to capture the data package going in and out of
the devices for debugging and troubleshooting purpose. You can set up the
PCAP on the device web interface properly before using it.
To do the configuration, you can do as follows:
1. Click Upgrade - Advanced to find PCAP.
2. Set up parameters properly.
3. Start PCAP data packets capturing by clicking on Start tab.
4. Stop PCAP data packets capturing by clicking on the Stop tab.
5. Export the data packets captured by PCAP by clicking on Export tab.
Parameters Set-up:
Specific Port: select the specific ports range from 1-65535 so that only the
data packet from the specific port can be captured. You can leave the field
blank by default.
PCAP: click Start tab and Stop tab to capture the a certain range of data
packets before clicking Export tab to export the data packets to you Local
PC.
To Next Page
Loading...
Need help?
General
