Akuvox R20B Series User Manual

56
R20B
Admin Guide
2. Enable/Disabled this feature.
3. Enter the authentication user name and password.
Parameters Set-up:
 Switch: Enable/disable the HTTP command unlock function by clicking on
Enable field
 UserName: Enter the User name of the device web interface, for example
“Admin”
 Password: Enter the password for the HTTP command. For example :
“12345”
 HTTP URL: The url must contain the IP address of the door phone, the
authentication information and which door you want to open.
 Please refer to the following URL example:
http://192.168.35.127/fcgi/do?action=OpenDoor&UserName=admin&Passwor
d=12345&DoorNum=1
5.7.6. Unlock via Exit Button
When you need to open the door from inside using the Exit button installed by
the door, you can configure the door phone Input A/B to trigger the two relay
switches maximum for the door access.
To do the configuration, you can do as follows:
1. Click Intercom- Input to find Input A/B.
2. Click to enable the Input function in the Input Service field.

Akuvox R20B Series Specifications

General

Brand	Akuvox
Model	R20B Series
Category	Intercom System
Language	English