PCAP Auto Refresh: select “Enable” or “ Disable” to turn on or turn off the
PCAP auto fresh function. If you set it as “ Enable” then the PACP will
continue to capture data packet even after the data packets reached its 1M
maximum in capacity. If you set it as “ Disable” the PCAP will stop data
packet capturing when the data packet captured reached the maximum
capturing capacity of 1M.
5.12.Integration
5.12.1. Integration via HTTP API
HTTP API is designed to achieve an network-based integration between the
third party device with the Akuvox intercom device such R29 series door phone.
You can configure the HTTP API function on the web interface for the
integration.
To do the configuration, please do as follows:
1. Click Intercom - HTTP API.
2. Set up parameters properly.
3. Click Submit tab for validation and Cancel tab for Cancellation.
To Next Page
Loading...
Need help?
General
