schedule.
Power On + Repeatedly: Combined with Power On mode and
Repeatedly mode. Device will start to do AutoP when every time it boots
up or by following the schedule.
Hourly Repeat: Device will start to do AutoP every hour.
5.15.1.3. Procedure to setup AutoP
A complete automatic upgrade process consists of the following:
1. Administrator sets up the NPS and ACS servers with the required
information;
2. Device gets the URL of the TFTP/FTP /HTTP/HTTPS server;
3. Device download the configuration file from the configuration server with
URL.
4. If configuration file contains the content for updating any configurations or
upgrading the firmware, device will get the firmware and do a firmware
update.
By default, a profile resync is only attempted when Akuvox products are idle,
because the upgrade might trigger a software reboot interrupting a call.
5.15.2. PNP for Autop
PNP stands for Plug and Play (Plug and Play). PNP provides a proprietary
automatic upgrade, when PNP upgrade mode is enabled, the phone will
broadcast a “SIP SUBSCRIBE” in the network. A SIP server will reply with a
“SIP NOTIFY” with the URL of the firmware and/or configuration file server.
To Next Page
Loading...
Need help?
General
