General Security Commands
Page 118 7450 ESS System Mangement Guide
Syntax application app [ip-int-name|ip-address]
no application app
Context config>system>security>source-address
Description This command specifies the use of the source IP address specified by the source-address command.
Parameters app — Specify the application name.
Values cflowd, dns, ftp, ntp, ping, ptp, radius, snmptrap, sntp, ssh, syslog, tacplus, telnet,
traceroute, mcreporter
ip-int-name | ip-address — Specifies the name of the IP interface or IP address. If the string contains
special characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
application6
Syntax application6 app ipv6-address
no application6
Context config>system>security>source-address
Description This command specifies the application to use the source IPv6 address specified by the source-
address command.
Parameters app — Specify the application name.
Values cflowd, dns, ftp, ntp, ping, radius, snmptrap, syslog, tacplus, telnet, traceroute
ipv6-address — Specifies the name of the IPv6 address.
telnet-server
Syntax [no] telnet-server
Context config>system>security
Description This command enables Telnet servers running on the system.
Telnet servers are off by default. At system startup, only SSH servers are enabled.
Telnet servers in networks limit a Telnet clients to three retries to login. The Telnet server disconnects
the Telnet client session after three retries.
The no form of the command disables Telnet servers running on the system.
To Next Page