Security
7450 ESS System Mangement Guide Page 187
Generic 802.1x COMMANDS
dot1x
Syntax [no] dot1x
Context config>system>security
Description This command creates the context to configure 802.1x network access control on the router.
The no form of the command removes the 802.1x configuration.
radius-plcy
Syntax [no] radius-plcy
Context config>system>security> dot1x
Description This command creates the context to configure RADIUS server parameters for 802.1x network access
control on the router.
NOTE: The RADIUS server configured under the config>system>security>dot1x>radius-plcy con-
text authenticates clients who get access to the data plane of the router as opposed to the RADIUS
server configured under the config>system>radius context which authenticates CLI login users who
get access to the management plane of the router.
The no form of the command removes the RADIUS server configuration for 802.1x.
retry
Syntax retry count
no retry
Context config>system>security> dot1x
Description This command configures the number of times the router attempts to contact the RADIUS server for
authentication if there are problems communicating with the server.
The no form of the command reverts to the default value.
Default 3
Parameters count — The retry count.
Values 1 — 10
To Next Page
Loading...
