SNMP System Commands
Page 302 7450 ESS System Mangement Guide
The no form of the command reverts to the default value.
Default 161
Parameters port-number — The port number used to send SNMP traffic other than traps.
Values 1 — 65535 (decimal)
packet-size
Syntax packet-size bytes
no packet-size
Context config>system>snmp
Description This command configures the maximum SNMP packet size generated by this node. If the packet size
exceeds the MTU size of the egress interface the packet will be fragmented.
The no form of this command to revert to default.
Default 1500 bytes
Parameters bytes — The SNMP packet size in bytes.
Values 484 — 9216
snmp
Syntax snmp
Context config>system
Description This command creates the context to configure SNMP parameters.
streaming
Syntax snmp
Context config>system>snmp>streaming
Description This command enables the proprietary SNMP request/response bundling and TCP-based transport
mechanism for optimizing network management of the router nodes. In higher latency networks,
synchronizing router MIBs from network management via streaming takes less time than
synchronizing via classic SNMP UDP requests. Streaming operates on TCP port 1491 and runs over
IPv4 or IPv6.
To Next Page
Loading...
