Event and Accounting Logs
7450 ESS System Mangement Guide Page 475
igmp_snooping, ip, ipsec, isis, l2tp, lag, ldp, li, lldp, logger, mcpath, mc_redun-
dancy, mirror, mld, mld_snooping, mpls, mpls_tp, msdp, nat, ntp, oam, open_flow,
ospf, pim, pim_snooping, port, ppp, pppoe, ptp, radius, rip, rip_ng, route_policy,
rsvp, security, snmp, stp, svcmgr, system, user, video, vrrp, vrtr, wlan_gw, wpp
message
Syntax message {eq | neq} pattern pattern [regexp]
no message
Context config>log>filter>entry>match
Description This command adds system messages as a match criterion.
The no form of the command removes messages as a match criterion.
Parameters eq — Determines if the matching criteria should be equal to the specified value.
neq — Determines if the matching criteria should not be equal to the specified value.
pattern pattern — Specifies a message up to 400 characters to be used in the match criteria.
regexp — Specifies the type of string comparison to use to determine if the log event matches the
value of message command parameters. When the regexp keyword is not specified, the default
matching algorithm used is a basic substring match.
number
Syntax number {eq | neq | lt | lte | gt | gte} event-id
no number
Context config>log>filter filter-id>entry entry-id>match
Description This command adds an SR OS application event number as a match criterion.
SR OS event numbers uniquely identify a specific logging event within an application.
Only one number command can be entered per event filter entry. The latest number command
overwrites the previous command.
The no form of the command removes the event number as a match criterion.
Default no event-number — No event ID match criterion is specified.
Parameters eq | neq | lt | lte | gt | gte — This operator specifies the type of match. Valid operators are listed in the
table below. Valid operators are:
Operator Notes
eq equal to
neq not equal to
To Next Page
Loading...
