Log Filter Entry Match Commands
Page 476 7450 ESS System Mangement Guide
event-id — The event ID, expressed as a decimal integer.
Values 1 — 4294967295
router
Syntax router {eq | neq} router-instance [regexp]
no router
Context config>log>filter>entry>match
Description This command specifies the log event matches for the router.
Parameters eq — Determines if the matching criteria should be equal to the specified value.
neq — Determines if the matching criteria should not be equal to the specified value.
router-instance — Specifies a router name up to 32 characters to be used in the match criteria.
regexp — Specifies the type of string comparison to use to determine if the log event matches the
value of router command parameters. When the regexp keyword is specified, the string in the
router command is a regular expression string that will be matched against the subject string in
the log event being filtered.
severity
Syntax severity {eq | neq | lt | lte | gt | gte} severity-level
no severity
Context config>log>filter>entry>match
Description This command adds an event severity level as a match criterion. Only one severity command can be
entered per event filter entry. The latest severity command overwrites the previous command.
The no form of the command removes the severity match criterion.
Default no severity — No severity level match criterion is specified.
lt less than
lte less than or equal to
gt greater than
gte greater than or equal to
Operator Notes
To Next Page
Loading...
