Event and Accounting Logs
7450 ESS System Mangement Guide Page 481
Event Trigger Commands
event-trigger
Syntax event-trigger
Context config>log
Description This command enables the context to configure log events as triggers for Event Handling System
(EHS) handlers.
event
Syntax [no] event application-id event-name-id
Context config>log>event-trigger
Description This command configures a specific log event as a trigger for one or more EHS handlers. Further
matching criteria can be applied to only trigger certain handlers with certain instances of the log
event.
The no form of the command removes the specified trigger event.
Parameters application-id — Specifies the type of application that triggers the event.
Values application_assurance | aps | atm | bgp | calltrace | cflowd | chassis | debug | dhcp |
dhcps | diameter | dynsvc | efm_oam | elmi | ering | eth_cfm | etun | filter | gsmp |
gmpls | igh | igmp | igmp_snooping | ip | ipsec | isis | l2tp | lag | ldp | li | lldp | lmp |
logger | mcpath | mc_redundancy | mirror | mld | mld_snooping | mpls | mpls_tp |
msdp | nat | ntp | oam | open_flow | ospf | pim | pim_snooping | port | ppp | pppoe |
radius | rip | rip_ng | route_policy | rsvp | security | snmp | stp | svcmgr | system |
user | video | vrrp | vrtr | wlan_gw | wpp
event-name-id — Specifies the name or numerical identifier of the event.
Values 0 — 4294967295 | event-name: 32 characters max
trigger-entry
Syntax [no] trigger-entry entry-id
Context config>log>event-trigger>event
Description This command configures an instance of a trigger for an EHS handler. A trigger entry binds a set of
matching criteria for a log event to a particular handler. If the log event occurs in the system and
matches the criteria configured in the associated log filter then the handler will be executed.
The no form of the command removes the specified trigger entry.
To Next Page
Loading...
