Event Trigger Commands
Page 482 7450 ESS System Mangement Guide
Parameters entry-id — Specifies the identifier of the EHS event trigger entry.
Values 1 — 1500
event-handler
Syntax event-handler event-handler
no event-handler
Context config>log>event-trigger>event>trigger-entry
Description This command configures the event handler to be used for this trigger entry.
Parameters event-handler — Specifies the name of the event handler. Can be up to 32 characters maximum.
log-filter
Syntax log-filter filter-id
no log-filter
Context config>log>event-trigger>event>trigger-entry
Description This command configures the log filter to be used for this trigger entry. The log filter defines the
matching criteria that must be met in order for the log event to trigger the handler execution. The log
filter is applied to the log event and, if the filtering decision results in a ‘forward’ action, then the
handler is triggered.
It is typically unnecessary to configure match criteria for ‘application’ or ‘number’ in the log filter
used for EHS since the particular filter is only applied for a specific log event application and
number, as configured under config>log>event-trigger.
Parameters filter-id — Specifies the identifier of the filter.
Values 1 — 1500
To Next Page
Loading...
