Syslog Commands
Page 486 7450 ESS System Mangement Guide
Only a single threshold level can be specified. If multiple levels are entered, the last level entered will
overwrite the previously entered commands.
The no form of the command reverts to the default value.
Parameters value — The threshold severity level name.
Values emergency, alert, critical, error, warning, notice, info, debug
port
Syntax port value
no port
Context config>log>syslog syslog-id
Description This command configures the UDP port that will be used to send syslog messages to the syslog target
host.
The port configuration is needed if the syslog target host uses a port other than the standard UDP
syslog port 514.
Only one port can be configured. If multiple port commands are entered, the last entered port
overwrites the previously entered ports.
The no form of the command reverts to default value.
Default no port
Parameters value — The value is the configured UDP port number used when sending syslog messages.
Values 1 — 65535
Router
severity level
Numerical Severity
(highest to lowest)
Configured
Severity
Definition
0 emergency system is unusable
3 1 alert action must be taken immedi-
ately
4 2 critical critical condition
5 3 error error condition
6 4 warning warning condition
5 notice normal but significant condition
1 cleared
2 indeterminate
6 info informational messages
7 debug debug-level messages
To Next Page
Loading...
