Show Commands
Page 538 7450 ESS System Mangement Guide
application application — Displays only events generated by the specified application.
Default All applications
Values chassis, dhcp, debug, filter, ip, isis, lag, ldp, logger, mirror, mpls, oam, ospf, port,
ppp, rip, route_policy, rsvp, security, snmp, stp, svcmgr, system, user, vrrp, vrtr,
ospf_ng, ntp
expression — Specifies to use a regular expression as match criteria for the router instance string.
sequence from-seq [to-seq] — Displays the log entry numbers from a particular entry sequence
number (from-seq) to another sequence number (to-seq). The to-seq value must be larger than the
from-seq value.
If the to-seq number is not provided, the log contents to the end of the log is displayed unless the
count parameter is present in which case the number of entries displayed is limited by the count.
Default All sequence numbers
Values 1 — 4294967295
count count — Limits the number of log entries displayed to the number specified.
Default All log entries
Values 1 — 4294967295
router-instance — Specifies a router name up to 32 characters to be used in the display criteria.
message format — Specifies a message string up to 400 characters to be used in the display criteria.
msg-regexp — Specifies to use a regular expression as parameters with the specified message string.
subject subject — Displays only log entries matching the specified text subject string. The subject is
the object affected by the event, for example the port-id would be the subject for a link-up or
link-down event.
regexp — Specifies to use a regular expression as parameters with the specified subject string..
ascending | descending — Specifies sort direction. Logs are normally shown from the newest entry
to the oldest in descending sequence number order on the screen. When using the ascending
parameter, the log will be shown from the oldest to the newest entry.
Default Descending
Output Show Log-ID Output — The following table describes the log ID field output.
Label Description
Log Id
An event log destination.
Source
no — The event log filter is not currently in use by a log ID.
yes — The event log filter is currently in use by a log ID.
Filter ID
The value is the index to the entry which defines the filter to be
applied to this log's source event stream to limit the events output to
this log's destination. If the value is 0, then all events in the source log
are forwarded to the destination.
To Next Page
Loading...
