Basic CLI Command Reference
114 Basic System Configuration Guide
Parameters router-instance — Specify the router name or service ID.
Values
Default Base
neighbor
Syntax neighbor ip-address [ip-address...(up to 5 max)] [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>router>bgp
Description This command displays statistical BGP neighbor information at the configured interval until the
configured count is reached. This command is supported on the 7750 SR and 7950 XRS.
The first screen displays the current statistics related to the specified neighbor(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the rate-per-second for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters neighbor ip-address — Displays damping information for entries received from the BGP
neighbor. Up to 5 IP addresses can be specified.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Output
Sample Output
router-name: Base, management
service-id: 1 to 2147483647
To Next Page
Loading...
