128 Rockwell Automation Publication 1441-UM001B-EN-P - September 2012
Chapter 4 Loading and Unloading
Load a list to the Storage Card
The Emonitor software can load lists to either the Dynamix 2500 data collector
internal memory, or to an SD storage card. You control the destination for lists
with the Route Memory parameter in the Setup Utility screen in the Dynamix
2500 data collector:
• Set Route Memory to Internal to store lists and data in internal memory.
• Set Route Memory to Storage Card to store lists and data to the SD card.
The Route Memory parameter is not applicable when unloading
data. the Emonitor software can unload lists from both the
Dynamix 2500 data collector internal memory and the SD card
at the same time.
To Next Page
Loading...
Need help?
General
