Rockwell Automation Publication 1441-UM001B-EN-P - September 2012 31
Configuring the Dynamic 2500 Data Collector Chapter 2
Install USB Drivers
You can communicate between the Dynamix 2500 data collector and your
computer by installing specific USB driver files.
When you connect Dynamix 2500 data collector to a computer for the first time,
the computer identifies new mobile device hardware. The instrument requires a
USB driver installed on you computer. Once you have installed the driver, it will
not be required to be installed again
Follow these steps to install the USB driver files.
1. From the Dynamix 2500 data collector product CDROM USB Driver
folder, run the USB driver setup wizard.
2. From the Start menu, choose CMC USB Driver/Install.
To Next Page
Loading...
Need help?
General
